M SIX

Helix

6-Channel D Class Amplifier 6 x 100W

6 RCA Inputs

HELIX M SIX

One for all – no matter if 3-way, 2-way or subwoofer application, the 6-channel amplifier M SIX will always be the right choice.
With generously 100 Watts RMS per channel into both 4 Ohms and 2 Ohms load this amp really gets your speaker cones going despite its super-compact dimensions. On the other hand the M SIX stays totally cool thanks to its highly efficient Class D design topology. And even bridged configurations are possible, delivering up to 3 x 200 Watts RMS of clean and undistorted output power.
In addition a comprehensive and stunningly practical feature set leaves nothing to be desired. And finally the perfect sound tuning is no big deal thanks to its integrated crossover with all its setup options.

Features

  • Small footprint Class D amplifier with high output power of 100 Watts RMS @ 4 and 2 Ohms load
  • Start-Stop capability down to 6V supply voltage
  • 6-channel lowlevel input
  • Integrated, active crossover with highpass, lowpass, bandpass and subsonic
  • “Input mode” switch for channel E & F for flexible input signal routing
  • SMD (Surface Mounted Device) manufacturing technology combines minimum space requirement with maximum reliability
  • Exclusive, extremely compact and clean design with illuminated HELIX-logo and low heat dissipation thanks to extraordinary efficiency

Special features:

Start-Stop capability

The switched power supply of the HELIX M SIX assures operation even if the battery’s voltage drops down to 6 Volts during engine crank.

Brand

Amplifier Info (Car)

, , , , , , ,

Technical data
Power RMS ≤ 1% THD+N
– @ 4 Ohms 6 x 100 Watts
– @ 2 Ohms 6 x 100 Watts
– @ 1 Ohm
– bridged @ 4 Ohms 3 x 200 Watts
– bridged @ 2 Ohms
Max. output power per channel*  Up to 130 Watts RMS @ 4 / 2 Ohms
Amplifier technology  Class D
Inputs 6 x RCA / Cinch
1 x Remote In
Input sensitivity RCA / Cinch 0.5 – 6 Volts
Input impedance RCA / Cinch 20 kOhms
Input impedance highlevel
Outputs 6 x Speaker output
Output voltage RCA / Cinch
Signal converter for digital input
Frequency response 10 Hz – 30,000 Hz
Bass boost
Highpass 15 Hz – 4,000 Hz adjustable
Lowpass 40 Hz – 4,000 Hz adjustable
Bandpass 15 Hz – 4,000 Hz adjustable
Subsonic / HPF
15 Hz – 4,000 Hz adjustable
Phase
Slope high- / lowpass 12 dB/Oct.
Slope subsonic / lowpass
Signal-to-noise ratio digital input
Signal-to-noise ratio analog input 98 dB (A-weighted)
Distortion (THD) 0.05 %
Damping factor 100
Operating voltage 10.5 – 16 Volts (max. 5 sec. down to 6 Volts)
Idle current 1,550 mA
Fuse 2 x 35 A Maxi-fuse (APX)
Additional features Active, adjustable crossover, subsonic input mode switch channel E / F, subsonic, Start-Stop capability
Dimensions (H x W x D) 50 x 320 x 154 mm / 2.00 x 12.60 x 6.06”

SHOPPING CART

close